Check and Clean the Hydraulic
Unit Shrouds
Service Interval:
Before each use or daily
1.
Disengage the PTO and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
Raise the seat.
4.
Clean the debris and grass from the hydraulic unit
shrouds (Figure 74).
5.
Lower the seat.
Figure 74
1.
Hydraulic unit shrouds
Brake Maintenance
Adjusting the Parking Brake
Service Interval:
After the first 100 hours
Every 500 hours thereafter
Check to make sure brake is adjusted properly. This procedure
must be followed after the first 100 hours or when a brake
component has been removed or replaced.
1.
Drive the machine onto a level surface.
2.
Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
3.
Stop the engine, wait for all moving parts to stop, and
remove the key.
4.
Raise the back of the machine up and support the
machine with jack stands.
DANGER
Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
•
Use jack stand when supporting machine.
•
Do not use hydraulic jacks.
5.
Remove the rear tires from the machine.
6.
Remove any debris from the brake area.
7.
Rotate the drive wheel release handle to the
released
position. Refer to the
Using the Drive Wheel
Release Valves
section in Operation.
8.
Measure the overall length of the compression spring.
The correct length should be between 1-1/2 and
1-9/16 inches (3.8 and 4.0 cm). If the spring length is
within this range, no adjustment is needed. If it is not,
proceed to step 9.
9.
Hold the threaded rod end with a tool and adjust
the lock nut until the spring length is between 1-1/2
and 1-9/16 inches (3.8 and 4.0 cm) (Figure 75). Do
Not allow the cable to turn when the nuts are being
loosened.
48
Summary of Contents for 74901 Z Master 5000
Page 66: ...Schematics Wire Diagram Rev A 66 ...
Page 67: ...Notes 67 ...
