Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 1 to 5-1/2 inches
(25 to 140 mm) in 1/4 inch (6 mm) increments by relocating
the clevis pin into different hole locations.
1.
Move the transport lock to the lock position.
2.
Push on the deck lift pedal with your foot and
raise the mower deck to the transport position (also
the 5-1/2 inch (140 mm) cutting height position)
(Figure 27).
3.
To adjust, rotate the pin 90 degrees and remove the pin
from the height-of-cut bracket (Figure 27).
4.
Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and, insert the pin
(Figure 27).
5.
Push on the deck lift, pull back on the transport lock,
and slowly lower the mower deck.
1
3
2
G017027
Figure 27
1.
Deck lift pedal
3.
Transport lock
2.
Cut of height pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1.
Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
Figure 28
1.
Anti-scalp roller
4.
Flange Nut
2.
Spacer
5.
Bolt
3.
Bushing
Figure 29
1.
Anti-scalp roller
3.
Flange Nut
2.
Bushing
4.
Bolt
Figure 30
1.
Anti-scalp roller
4.
Flange Nut
2.
Spacer
5.
Bolt
3.
Bushing
23
Summary of Contents for 74901 Z Master 5000
Page 66: ...Schematics Wire Diagram Rev A 66 ...
Page 67: ...Notes 67 ...
