Toro 41393, Operator'S Manual

Page: 79 / 92

g028243
Figure 110
Agitation Valve Manifold
1. Stem retainer 7. Back seating O-ring (0.676
x 0.07 inch)
2. Valve stem 8. Valve-seat ring
3. Stem port 9. Manifold body
4. Stem-capture retainer
10. Ball valve
5. End-cap fitting 11. End-cap-fitting assembly
6. End-cap seal O-ring
(0.796 x 0.139 inch)
g028240
Figure 111
Section Valve Manifold
1. Valve-stem seat 7. End-cap O-ring (0.796 x
0.139 inch)
2. Valve-stem assembly 8. Back seating O-ring (0.676
x 0.07 inch)
3. Stem port 9. Ball seat
4. Stem retainer 10. Manifold body
5. Outlet fitting O-ring (0.737
x 0.103 inch)
11. Ball valve
6. Coupling (manifold) 12. Coupling assembly
(manifold)
3. Turn the valve stem so that the ball is in the
open position (
Figure 109 A).
Note:
When the valve stem is parallel with the
valve flow, the ball slides out.
4. Remove the stem retainer from the slots in the
stem port in the manifold (
Figure 110 and Figure
111 ).
5. Remove the stem retainer and valve stem seat
from the manifold (
Figure 110 and Figure 111 ).
6. Reach into the manifold body and remove the
valve-stem assembly (
Figure 110 and Figure
111 ).
7. Clean the inside of the manifold and exterior
of the ball valve, valve-stem assembly, stem
capture, and end fittings.
79