Toro 41393, Operator'S Manual

Page: 78 / 92

g191300
Figure 107
1. Flange (coupling adapter) 3. Section-manifold valve
2. Flange (section-manifold
valve) 4. Flange clamps
4. For left or right section-valve manifolds, remove
the 2 flange-head bolts (1/4 x 3/4 inch) and
2 flange locknuts (1/4 inch) that secure the
section-valve manifold to the valve support
(
Figure 108 ).
g191304
Figure 108
1. Flange locknut (1/4
inch—left and right
section-valve manifold
positions) 4. Flange (coupling adapter)
2. Section-bypass valve 5. Gasket
3. Quick-connect fitting
(section-valve manifold) 6. Flange-head bolt (1/4 x
3/4 inch—left and right
section-valve manifold
positions)
5. Move the section-valve manifold and gaskets
down to clear the section-bypass valve and then
away from the machine (
Figure 108 ).
Note:
If needed, loosen the mounting hardware
for the left or right section-valve manifolds as
needed to provide clearance.
Note:
Retain the flange clamps, gaskets and
quick-connect pins for installation in Installing
the Section-Manifold Valve (page 80) .
Cleaning the Manifold Valve
1. Position the valve stem so that it is in the closed
position (
Figure 109 B).
g027562
Figure 109
1. Valve open 2. Valve closed
2. Remove the 2 end-cap-fitting assemblies from
each end of the manifold body (
Figure 110 and
Figure 111 ).
78