Toro 41393, Operator'S Manual

Page: 34 / 92

Note:
Use the master section switch to start
and stop the flow of chemical s to the selected
spray sections.
11. When finished spraying, set the master section
switch to the O
FF
position to turn off all spray
sections, then set the spray-pump switch to the
O
FF
position.
Note:
Raise the outer spray sections to the
transport position and drive the sprayer to the
cleaning area.
Important:
Always raise the boom sections
until they have moved completely into
section-transport cradle forming the “X”
transport position and the lift cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
Spraying in the Manual Mode
Note:
This procedure assumes that the spray pump
is on; refer to Figure 31 in Spraying in the Application
Rate Mode (page 32) .
1. Ensure that the sprayer system is adjusted for
the active spray nozzles that you have selected;
refer to
Setting the Section-Bypass Valves (page
38) .
2. Set the sprayer mode button to the Manual
Mode (
Figure 32 ).
g192608
Figure 32
1. Manual mode position 2. Sprayer-mode switch
3. Set the master section switch to the O
FF
position; refer to Figure 30 in Spraying in the
Application Rate Mode (page 32) .
4. Adjust the throttle to the desired engine speed
to spray; refer to
Figure 31 in Spraying in the
Application Rate Mode (page 32) .
5. Drive to the spraying location.
6. Lower the sections into position.
7. Set the individual section switches, as needed,
to the O
N
position; refer to Figure 30 in Spraying
in the Application Rate Mode (page 32) .
8. Use the application-rate switch to achieve the
desired spray pressure as indicated in the
nozzle-selection guide provided with the sprayer
(
Figure 33 ).
g193782
Figure 33
1. Application-rate switch
9. Drive at the desired speed and then set the
master section switch to the O
N
position to begin
spraying; refer to Figure 30 in Spraying in the
Application Rate Mode (page 32) .
Note:
When the tank is nearly empty, the
agitation may cause foaming in the tank. In
this case, turn the agitation switch to the O
FF
position. Alternatively, you can add anti-foaming
agent to the tank.
10. When you are finished spraying, set the master
section switch to the O
FF
position to turn off all
sections, then set the spray-pump switch to the
O
FF
position.
Note:
Return the sections to the transport
position and drive the sprayer to the cleaning
area.
Important:
Always raise the sections
until they have moved completely into
section-transport cradle forming the “X”
transport position and the section cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
34