Toro 03781, Service Manual

Page: 339 / 468

Reelmaster 7000−D Page 8 − 5 Chassis
7. Slide rubber bellows up steering column to allow ac-
cess to fasteners that secure steering control valve and
steering column to machine.
8. Support steering control valve to prevent it from shif-
ting during steering column removal.
9. Loosen and remove four (4) socket head screws
(item 5) that secure steering control valve to steering
column.
10.Loosen and remove four (4) socket head screws
(item 9) and flange nuts (item 10) that secure steering
column to machine.
11. Raise steering column assembly from steering con-
trol valve and machine.
12.Disassemble steering column assembly as needed
using Figure 4 as a guide.
Installation (Fig. 2)
1. Assemble steering column using Figure 4 as a guide.
After assembly, make sure that release pin on end of cyl-
inder shaft is positioned against the pedal. Jam nut on
cylinder shaft can be used to adjust location of release
pin.
2. Apply antiseize lubricant to input shaft of steering
control valve.
3. Slide steering column onto steering control valve.
Secure steering column in place with four (4) socket
head screws (item 9) and flange nuts (item 10).
4. Secure steering control valve to steering column with
four (4) socket head screws (item 5). Torque screws
from 7 to 10 ft−lb (10 to 13 N−m).
5. Slide rubber bellows to bottom of steering column.
6. Position column brace (item 12) in place and secure
with four (4) flange head screws.
7. Thoroughly clean tapered surfaces of steering wheel
and steering column.
8. Apply antiseize lubricant to splines of steering col-
umn taking care to keep antiseize lubricant from column
taper. Slide steering wheel onto steering column.
9. Secure steering wheel to steering column with flat
washer and lock nut. Torque hex nut from 20 to 26 ft−lb
(28 to 35 N−m).
10.Install steering wheel cover to steering wheel.
11. Install and secure platform shroud to machine
(Fig. 3).
2
3
4
5
6
1
4
1. Roller support
2. Screw (2)
3. Carriage screw (2)
4. Headlight assembly
5. Flange nut (2)
6. Platform
shroud
Figure 3
1. Steering column
2. Pin
3. Universal
joint
4. Pin
5. Lock washer (2)
6. Cylinder
7. Bolt
(2)
8. Pin
9. Pedal block
10. Pedal cover
11. Pedal
12. Spring
13. Release pin
14. Cylinder shaft
15. Jam nut
Figure 4
2
3
4
5
6
1
7
8
9
10
12
11
6
13
14 15
Chassis