Toro 03781, Service Manual

Page: 378 / 468

Reelmaster 7000--D
DPA Cutting Units
Page 9 -- 24
Reel Assembly (cutting units with painted side plates)
1. Bedbar assembly
2. Flange bushing (2 used)
3. Plastic washer (4 used)
4. Metal washer (2 used)
5. Bedbar pivot bolt (2 used)
6. Lock nut (2 used)
7. Shoulder bolt (3 used per side plate)
8. LH side plate
9. Weight
10. Cap screw (2 used)
11. O--ring
12. Cutting reel
13. Spline insert (LH thread)
14. RH side plate
15. Spline insert (RH thread)
16. Retaining ring (2 used)
17. Grease seal (2 used)
18. Bearing (2 used)
19. Bearing adjuster nut
20. Set screw
21. Cap screw (2 used)
22. Cutting unit frame
23. Flange nut (3 used per side plate)
Figure 33
FRONT
RIGHT
5
6
7
8
9
1
10
11
12
14
15
16
17
18
13
3
4
2
Grease OD surface
See text for
tightening
procedure
Loctite #243
Grease bore
and threads
27 to 33 ft--lb
(37 to 44 N--m)
27 to 33 ft--lb
(37 to 44 N--m)
12 to 15 in--lb
(1.4 to 1.7 N--m)
20
19
21
11
3
22
23
Grease
bore
Antiseize
Lubricant
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
spline inserts, grease seals and bearings) from the cut-
ting unit.
NOTE: Refer to Reel Assembly Service later in this sec-
tion for information on replacing cutting reel grease
seals, bearings and spline inserts.
NOTE:
Removal of the cutting reel requires removal of
the left side plate from the cutting unit frame. The right
side plate does not have to be removed from the frame.
Reel Assembly Removal (Fig. 33)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine and place
on a flat work area.
DP
A
C
utting
Units