©Tornado International Ltd. 2019
-16-
Confidential
2.00 Operating procedures
To ensure this product remains in good working order these instructions should be followed daily.
2.01 Opening instructions
1. Remove the console covers; visually check the consoles for any damage.
2. Turn the power supply on and check that the red lights are illuminated on each playing position.
3. Calibrate the forward/reverse sticks on each playing position by pushing them fully forward and fully
backward.
Note!
The power supply must always be turned on before the batteries are connected to the models.
3. Check the charge indicator LEDs on the battery chargers. All four should be illuminated green when the
battery is fully charged.
4. Remove the batteries from the chargers and insert the spare batteries if they are not fully charged.
5. With the boat near to the operating area and keeping the boat propellers clear of any obstructions,
carefully slide the battery into the boat. The propellers will rotate briefly.
6. Attach the boat top and lock it into position. Ensure it is the correct number for the receiver.
7. Carefully place the boat on the water inside the operating area.
Caution! Place the boat on the water. Never launch or throw the boat onto the water, as this will cause the
hull to fracture around the battery holder.
8. Repeat operations 5 to 7 for each model.
9. Coin and test each playing position in turn to ensure the console and boat operate correctly.
The unit is now ready for use.
2.02 Closing instructions
1. Trigger the playing position and drive the boat to the edge of the area and remove it from the water.
2. Place the boat on the stand supplied, remove the top and slide the battery out of the hull.
3. Inspect the propellers for damage or debris around the shaft.
4. Using polish and a cloth thoroughly clean the outside of the hull and top.
5. Place the boat vertically with the bows up in its storage position
Caution!
It is vital that the boat is stored vertically with the bows up to ensure that any water in the hull and water
in the outer propeller shafts drains out of the rear. Storing the boat in any other position will allow water
to enter the motors leading to their premature failure.
6. Repeat operations 1 to 5 for each model.
7. Turn off the power supply and check that all of the lights on the consoles are off.
8. Open the cash doors (remove the pad locks if fitted) and remove the cash.
9. Lock the cash doors and thoroughly clean and polish the consoles and playing positions. Place the
covers over the consoles.
10. Place the used batteries in the charger.
1N00-510 Genesis Boat User Manual v3 05/19
