©Tornado International Ltd. 2019
-11-
Confidential
1.07 Routing the PSU cable:
The PSU cable has to be routed from the PSU to the master console. This cable carries the 24V ac produced
by the PSU to the consoles.
Note!
The PSU cable must not be lengthened without consulting Tornado International Ltd.
1. Route the cable from the PSU to the master console.
2. Plug the PSU cable into the 24V socket in the master console. (See 1.06 Dia 1)
3. Starting at the master console fix the cable in place using 8mm cable clips.
4. Coil any excess cable next to the PSU.
Do not plug the PSU in to the mains outlet at this time.
1.08 The loop: (If you don’t have a loop system please ignore this section)
The loop is the aerial used by the transmitter (TX) to send the control signal to the models. We use a loop
type aerial because it concentrates the available transmitter power into the operating area for better
interference rejection. The loop wire will be found with the spares pack. If required, any wire of at least the
same cross sectional area can be used.
The loop wire forms a complete loop starting at the loop plug in the master console (See 1.06 Dia 1),
running around the perimeter of the model operating enclosure and ending back at the loop plug in the
master console (See Dia 1).
Model operating enclosure
Master console
Dia 1 – The loop aerial
Loop aerial
1N00-510 Genesis Boat User Manual v3 05/19
