Cold Metals Lab
V1.0 11/7/2017
Loading Tools into the ATC - Skip if only using 1 tool
1.
Navigate to ATC Menu
2.
Delete all tools in ATC menu
3.
Physically Remove any tools from spindle
4.
Make sure Tool in Spindle is listed as 0
5.
Click Go To Load position
6.
Physically Insert Tool into ATC Fork
7.
Assign tool numbers as tools are placed in ATC - Click insert
8.
Tray Rev/Fwd to turn ATC and load up to 10 tools, remember to click insert and assign tool numbers as you
load
9.
Click Retract to Move ATC to home position and clear the spindle
10.
Position Tool Setter on Zero Plane & Plug into control box
11.
Test Tool Setter Connection by depressing top and making the red light both physically and digitally comes
on.
12.
Once Tool Setter is tested and in position under spindle center click touch off entire tray. This will grab all
tools loaded in order and touch them off to the setter.