INSTALLATION MANUAL
7.7.6.2
FXS Settings
The FXS interface is associated with a direction name
(trunk 2 typically), it is relevant for a call coming in DISA
mode either from the GSM module or from the FXO
interface
7.7.6.3
FXO Settings
For the FXO interface, the settings for routing are:
-
Action, select either enables DISA that makes use
of dialing in by using DTMF, or uses a target.
-
Generate or not Dial tone for outgoing calls.
-
Target type, where you select either FXS or GSM.
-
Target, where you enter the number of the
destination of the call coming in via FXO
interface.
-
Direction, assigns the FXO port to a trunk.
Incoming calls:
-
if you have checked DISA
-
upon detection of ring signal, the call is answered, dial tone is generated or not
according to the setting in Category, digits are received in DTMF and according to the
routing table.
-
According to “Target type”, either a call towards GSM with the phone number will be
initiated, or ringing signal is sent to the FXS interface.
-
if the check box DISA is not marked
-
upon detection of ring signal, the call is directed to the port that you have entered in
the field Target Type. Thus, if the target in a mobile phone number, a call will be
initiated towards the mobile network, using the phone number form the field target;
should the Target type be FXS, then a call is sent to the FXS interface
Settings:
-
FXO has associated a direction name, typically Trunk1; when the number dialed over the
FXS or GSM ports in mode DISA corresponds to the direction associated with the FXO port,
the call will be performed via this port!
page 46 / 60