VoiBRIDGE / VoxiPlus INSTALLATION MANNUAL
© 2008 TOPEX S.A.
page
26
4.2
Connection for configuring
There are two possibilities: either you configure the Topex gateway locally, by means of the
serial connection, or you have access to the VoiBRIDGE system by IP. After you have successfully
connected the equipment to a LAN network or to the Internet, the change of address may be
performed also remotely, by using a
ssh
communication program such Putty or directly from the
Linux command line.
However, in order to avoid errors in changing the address, errors that could cause loss of
connection to the equipment, it is
strongly recommended
to change the address locally, via serial
cable.
4.2.1 Direct serial connection
In order to change the IP address you must connect to the Topex gateway from a desktop or
notebook computer using the serial (RS-232) connection.
Verify that the special serial cable is properly connected
Set the COM properties of your computer to match the parameters of the VoiBridge serial
connection (Bits per second - 115200; Data bits – 8; Parity – None; Stop bits - 1; Flow
Control – None).
See below an example for the Windows XP operating system:
Select
Start
>
Control Panel
>
System
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
