VoiBRIDGE / VoxiPlus INSTALLATION MANNUAL
© 2008 TOPEX S.A.
page
48
APPENDIX 3 – Additional Commands
To see the listing of all AT commands that are available on your particular equipment, you must
issue the command "
help
":
set pin sim sss pppp
Used to set the pin codes for GSM modules at module "sss".
The pin code is "pppp";
set pin range sss sss pppp
Used to set the pin codes for GSM modules in range "sss" to
"sss". The pin code is "pppp";
set/res moni ppp
used to put / extract a GSM port from monitoring state
send gsm at.......
Used to dial a number
set debug ppp ppp
Used to start debugging on a port. The port for debugging
purposes is completed in "ppp" section: for example to activate
debug for port 1 the command is "set debug 1 2"
set view ppp
Must be sent to port "ppp" after the command "start debug ppp
ppp" in order to activate the debugging facility
res debug ppp ppp
Used to stop debugging on port "ppp". The port is completed in
"ppp" section: to stop the debugging for port "1" the command is
"res debug 1 2"
res view ppp
Must be sent to port "ppp" after the command "res debug ppp
ppp" in order to deactivate the debugging facility
set tmax sss sss ttt
Allows you to define a time interval ('ttt') after which a SIM will
be blocked. “sss” is the sim coresponding value. You may
specify a range of SIM cards values. Value of 'sss' may be
computed as follows: number of card (shown in "Port status) * 8
+ number of sim (0,1,2 or 3) for the first GSM module or number
of card (shown in "Port status) * 8 + 4 + number of sim (0,1,2 or
3) for the second GSM module.
set calls
It is used for displaying the total number of call attempts
("TCalls"), answered calls ("T spech"), total duration of calls
("Dcalls"), total duration of speaking ("Dspech) and the number
of calls released from "A" side ("Arelease") and from "B" side
("Brelease")
set calls off
This command is used to reset the previous values
set block ppp ppp
Command used to send block message on SS7 signaling to
channels in range ppp ppp
res block ppp ppp
Command used to send unblock message on SS7 signaling to
channels in range ppp ppp
set loop ppp ppp
Command used to send loop message on SS7 signaling to
channels in range ppp ppp
res loop ppp ppp
Command used to send unloop message on SS7 signaling to
channels in range ppp ppp
kill call port
This command disconnects an active call on a GSM module.
The position of the GSM module is specified by the "port"
parameter
test callbqack id
This command is used for making tests over the quality of voice.
In this chapter this command is detailed presented
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
