Topens AT602, User Manual

Page: 13 / 27

11
Step 3
Insert the cable of the motor2 and alarm lamp cables into the control box through middle strain relief. Then
repeat step 2.
Step 4
Insert other cables into the control box through rightmost strain relief. Then repeat step 2.
CAUTION: Make sure the cable outlet hole in the Control Box is always down during installation so as to drain
off the water.
Connection of Power Supply
WARNING: NEVER connect the gate opener
to the power supply before all the installations
have been done.
Connect the power supply to the Control Box refers to
the following illustration.
NOTE:
1. Use copper conductors to connect to the power
supply terminals.
2. The wire (not provided) size should be at least
0.75mm2 (18AWG) which is intended to connect the
power supply.
3. Run the wires in conduit to the control box to
prevent damage to the wires from lawn mowers, weed
eaters and grazing animals.
4. The
fuse in the control board is interchangeable. A 10a, 250vac, Φ5*20mm fuse is suitable to the control
board.
Connecting of the Control Board
Actuator 1
Insert the stripped cable wires into the appropriate terminals on the opener terminals block. The red wire should
be inserted into the “ ” terminal, the black wire into “ MOTOR1-“ , the blue wire into ULT1 , the green
wire into COM , and the thin yellow wire into DLT1 terminal.
Actuator 2
Similar as the connection of Actuator 1 , insert the stripped cable wires into the appropriate terminals on the
opener terminals block. The red wire should be inserted into the “ ” terminal, the black wire into
“ MOTOR2-“ , the blue wire into ULT2 , the green wire into COM , and the yellow wire into DLT2 terminal.
NOTE: For dual gate mode, actuator 1 must be used for master gate. Master gate would open first and
close last. If the gate opener is installed for “PUSH TO OPEN”, then the P2 setting of the control board
must be set to “11” (Factory default setting is 00).