16
2.2 Continuous Measurement (Auto Run)
The procedures to perform continuous measurement are described below.
Remember
The measurement data is stored at the number next to the data number being
indicated on the screen. When there is the data registered with the same
number, the existing data is overwritten.
1.
Change the measuring method to continuous measurement.
Setting of the measuring method:
☞
“3.2 Measurment Mode”.
2.
Press the [MEAS./HOLD] switch.
Note
• In continuous measurement, the integral time is not indicated. Be careful for this
difference compared with single measurement.
• Each time measurement is ended, the data number “#**” is increased.
3.
To finish the measurement, press the [MEAS./HOLD] switch. “HOLD” on the panel switch is
lit and the measurement result is indicated.
Ｒｕｎ
ＡＵＴＯ
ＡＢＳ
２．０
[
ｆ１
] 2
．０
６００ｎｍ
＝
１．４４６８Ｅ＋０２
１０３０ｎｍ
＝
２．４４６６Ｅ＋０２
Ｒｕｎ
ＡＵＴＯ
ＡＢＳ
２．０
[
ｆ１
] 2
．０
６００ｎｍ
＝
１．４４６８Ｅ＋０２
１０３０ｎｍ
＝
２．４４６６Ｅ＋０２
During measurement, “Run” is indicated at the data number section.
