Topcon GLS-1000 SERIES, Instruction Manual

Page: 56 / 76

7-5
7 Station Setting
7
Input backsight point name [b-1].
Input
backsight
point name
8
Press the [ENT] key.
[ENT]
9
Collimate to the center of backpoint target by
using Horizontal/Vertical jog.
Collimate to
a target
10
Press the [ENT] key.
Scanning of the backsight point will start.
REMAIN: remaining time of the scan
[ENT]
11
When scanning of the backsight point is correctly
completed, an end message will be displayed.
Then, press the [ENT] key. *1) *2)
12
The mirror will rotate toward the backsight point.
Look into the sighting collimator and confirm the
position of the backsight point that was scanned.
When the backsight point is correctly collimated,
select the F1 (FINISH) key.
When the backsight point is not correctly
collimated, there is a possibility of a reflecting
object other than the target being scanned. Select
either the F2 (REVOKE) or F3 (SCAN AGAIN) key
and redo.
The backsight point name and the occupied point
name are set.
[ENT]
[F1]
*1) If the instrument is tilted 10' or more, the screen
shown below will be displayed.
OCC/BS SETTING
INPUT BS NAME
[b-1 ]
ALPH <-
OCC/BS SETTING
AREA SELECT
AIM TO TARGET
AND PRESS ENT KEY
OCC/BS SETTING
SCANNING IN PROGRESS
REMAIN 10S
PAUSE STOP
OCC/BS SETTING
FINISHED
PRESS ENT KEY
OCC/BS SETTING
PLEASE PEEP TARGET
F1 FINISH F2 REVOKE
F3 SCAN AGAIN
STATION MENU
F1 NEW STATION
F2 SELECT STATION
F3 OCC/BS SETTING
TILT OVER
PRESS ENT KEY
TARGET SCANNING
SCAN START
PRESS ENT KEY
ENT
After leveling the instrument,
press the [ENT] key.