Top Air TA1200, Operator'S Manual And Parts List

Page: 27 / 102

2-15
Operation
400984
•
Chemical Container and
Inductor Tank Rinsing
Both chemical containers and the inductor
tank itself can be rinsed by using clean
water from the rinse tank. To do so,
ensure that the rinse tank is at least 1/2
full, and use the following procedure:
1. Perform steps 1 through 4 under
“Basic Operation” of inductor.
2. Quickly move PUMP INLET
SELECTOR valve from <SOLUTION
TANK> to <RINSE TANK >.
NOTE: It is recommended to work
efficiently while the sprayer pump is
drawing from the rinse tank, as the rinse
water is returned to the solution tank not
the rinse tank, and therefore the rinse tank
will eventually become empty.
IMPORTANT: Do not allow pump to run
dry. Pump damage will result.
3. To rinse a chemical container, place
container upside down on rinse nozzle
and squeeze handle on rinse wand.
4. To rinse inductor tank, close lid , open
INDUCTOR MIX valve and squeeze
rinse wand handle for approximately
10 seconds.
5. Close INDUCTOR MIX valve and
release rinse wand when rinsing is
complete.
6. Repeat steps 4 and 5 for additional
rinsing, if desired.
7. When inductor tank is empty, close
INDUCTOR DRAIN valve, and
quickly move PUMP INLET
SELECTOR valve from <RINSE
TANK> to <SOLUTION TANK > to
minimize the amount of rinse water
used.
8. Close INDUCTOR FLOW valve then
set AGITATION CONTROL and
FILTER PURGE CONTROL to
proper settings.
9. Raise tank to storage position.