2-9
Operation
2.
Press and hold
OUTER WING
switch in
<RETRACT>
position until
outer wings are fully retracted.
3.
Press and hold
MAIN BOOM
switch
in
<RAISE>
position until boom is
fully raised.
4.
Press and hold
RH WING TILT
and
LH WING TILT
switches in
<UP>
position until wings are fully tilted
upward.
5.
Press and hold
INNER WING
switch
in
<RETRACT>
position until wings
are fully retracted.
6.
Press and hold either
RH WING TILT
or
LH WING TILT
switch in
<DOWN>
position until each wing is
seated in its wing rest. Repeat for
opposite wing.
Note:
Wing tilt
function may require several
seconds of use before wings begin
to move.
7.
Press and hold
MAIN BOOM
switch
in
<LOWER>
position to allow boom
to lower approximately 6 inches until
transport lock is engaged.
NOTE:
If boom does not engage
transport lock, raise boom fully, press
and hold
INNER WING
switch in
<RETRACT>
position for 5 seconds,
then repeat step 7.
•
Folding Boom
WARNING: Keep all personnel a
safe distance away from the sprayer
when unfolding or folding the boom.
Personal injury can result from
contact with boom.
WARNING: Perform boom
unfolding and folding operations only
in areas with adequate height, width
and length clearances. In particular,
be mindful of location of overhead
power lines. Failure to do so can
result in personal injury and property
damage.
1.
Press top of
ON/OFF
switch to turn
power on. (Red LED lamp on rocker
switch should illuminate. Green LED
lamp is provided to indicate circuit
continuity whenever any other switch
is pressed.)
401965
BOOM
CONTROL
RETRACT
EXTEND
RETRACT
EXTEND
Summary of Contents for TA1200
