9. Insert the servo lead into the cutout
channel and thread the servo
connector through the foam wing to
the other side.
You can carefully use a flathead
scredriver to accomplish this step of
the build.
Repeat steps 5 through 9 to finish the
other wing panel.
8. Cut free both sides of the ailerons using
a sharp hobby knife. Carefully bend the
ailerons up and down to „loosen“ the
hingeline. Make sure not to overextend the
ailerons
DO NOT cut off the ailerons at the
hingeline.
7. Install the thin fiberglass rod on the
bottom of the wing and glue into place
using CA, applying it to the full length of
the fiberglass rod. If needed shorten the
fiberglass rod to the right length.
Tomahawk Design 89284 Pfaffenhofen GERMANY
Keine Haftung für Druckfehler Technische Änderungen vorbehalten Stand 09-2010
Made in Germany
Seite 9
