4. Install the fiberglass tubes using CA.
6.Conect the servo (2) with the servo
linkage (1) !ATTENTION! Test the sub trim
of the servo. Only apply glue to the servo
flaps when you install them in the prepared
servo cutouts on the bottom of the wing.
Extend the servo lead to a total length of
55mm or 2.2 inches. Test the settup when
done.
5. Insert the joint (1) (milled from
aluminum) into the ruder horn (2) (cast
part). Loosely install the M3 (Metric size
3) set screw (3)
(4) Glue the ruderhorn assembly into
place.
3
2
1
4
2
1
Tomahawk Design 89284 Pfaffenhofen GERMANY
Keine Haftung für Druckfehler Technische Änderungen vorbehalten Stand 09-2010
Made in Germany
Seite 8
