Rudder Assmebly
16. Insert the joint (milled from aluminum)
into the ruder horn (cast part). Loosely
install the set screw. Glue the whole
assembly in place.
18. Cut free both sides of the rudder using
a sharp hobby knife. Carfully bend the
rudder left and right to „loosen“ the
hingeline. Make sure not to overextend the
ailerons
DO NOT cut off the rudder at the
hingeline.
17. Extend the total length of the servo
leads to 60mm or 2.4 inches. Install the
servos
including
the
linkages.
!ATTENTION! Test the servos sub trim
before proceeding and apply glue only to
the servo flaps. Adjust the length of the
linkage if needed.
Tomahawk Design 89284 Pfaffenhofen GERMANY
Keine Haftung für Druckfehler Technische Änderungen vorbehalten Stand 09-2010
Made in Germany
Seite 12
