PLS-601 User's Manual
Document #11696 Page - 17
4.2.1 PLS-601 CHANGE PROGRAM NUMBER
Once the power to the PLS-601 has been applied, one of the four programs must be selected by
entering the desired program number (PROG). To accomplish this task, make sure the MODE
switch is in the ‘PROGRAM’ position. The following describes how to change the PROGRAM
number of the PLS-601.
CHANGE PROGRAM NUMBER:
CHANGE PROGRAM NUMBER DISPLAY:
PROG
1
P000-R000
(Highlighted character indicates blinking character that can be changed)
Select:
1 2 3 or 4 (Blinking character will change accordingly)
or Select:
INC (Blinking character will INCrement to next value)
or Select
DEC (Blinking character will DECrement to next value)
or Select
CLEAR (Selects PROGRAM NUMBER 1)
New Display:
PROG
2
P000-R000
Select:
ENTER
Selects the new program number into memory for data entry
to begin. The FUNCTION LED becomes active and the
display prompt for PROGRAM NUMBER stops blinking.
New Display:
PROG 2 P000-R000
4.2.2 TACHOMETER Function
The TACHOMETER function is used to display the selected PROGRAM NUMBER (PROG), the
RESOLVER shaft position (P) in degrees, and the RESOLVER shaft speed (R) in RPM. This
function does not allow for data entry.
TACHOMETER DATA Function:
Select:
POS/TACH
Selects the POS/TACH function in order to display the current
RESOLVER shaft position in degrees and RESOLVER shaft speed in
RPM.
New Display:
PROG 2 P000-R000
