D3000000A
RESTRICTION FOR USE
Avoid irregular signal interface.
Do not attempt irregular signal interface other than specified. Under signal interface other than
recommended/specified in this instruction manual, the device might fail to exert the maximum
performance. In much worse case, if you continue to use your device under incorrect signal
interface, part(s) of inner circuits might burn down.
DISCLAIMER (LIMITED WARRANTY)
We assume no responsibility and shall be held harmless for damage or loss incurred by the user
in the following cases.
1.In the case where damage or loss is caused by fire, earthquake, or other acts of Gods, acts
by a third party, misuse by the user deliberately or erroneously, or use under extreme
operating conditions.
2.In the case where any indirect, additional, consequential damages (e.g. loss of expected
interest, suspension of business activities) are incurred as results of a malfunction or
non-functioning of this device, we shall be exempted from assuming responsibility for such
damages.
3.In the case where damage or loss is caused by incorrect use which is not in line with the
instructions given in this operation manual.
4.In the case where damage or loss is caused by a malfunction resulting from bad connection
with other equipment.
5.In the case where damage or loss is caused by repair or modification done by the user.
OTHER INSTRUCTIONS
Do NOT use power other than specified
Be sure to use DC12V power supply. The camera is designed to work only under the specified
voltage. Do NOT attempt to drive the camera with the power other than DC12V. Operating the
camera under power other than DC12V invites a fire or a electric shock hazard.
Avoid intensive light
Do NOT expose the camera’s image-pickup-plane to sunlight or other intense light directly. If the
part of CCD is exposed to spot-intensive light, you might get a picture problem like blooming
and/or smear. You might observe vertical stripes on your monitor if your camera is exposed to
sunlight (or any other intensive light), however, this is not a malfunction. Redirect your CH
(camera-head) to different directions in such case.
