34
[Shutter trigger spec]
Exposure-starting-cue signal in random trigger shutter mode
Input level LOW level: 0~0.5V
HIGH level: 4~5V
Input impedance High impedance (10k-ohm)
Capture timing Rising edge detection (Positive) / Falling edge detection (Negative)
(Switching via rear-panel DIP SW)
(Initial factory setting: Rising edge)
Pulse width Under DIP SW setting: Minimum 2.5 micro s, Maximum 1/6s
Under pulse width setting: Minimum 2.5 micro s, Maximum 1/8s
[E-shutter spec]
(1)Normal shutter Shutter-speed setting via rear-panel SW (Initial: OFF)
Selection among 8 scales (= OFF, 1/250s, 1/500s, 1/1000s, 1/2000s
1/4000s, 1/8000s, 1/20000s)
(2)RTS
(a)Operation mode
No.
Reset
Exposure
Sync
1
Internal
2
Consecutive HD /
Consecutive VD
3
Consecutive HD /
Single VD IN
4
Internal
5
Consecutive HD /
Consecutive VD
6
Consecutive HD /
Single VD IN
7
Internal
8
Consecutive HD
9
Internal
10
TRIG pulse
width
(PULSE
mode)
Consecutive HD
IN
Rear SW
(FIX mode)
Non-reset
Rear SW
(FIX mode)
TRIG pulse
width
(PULSE
mode)
V-reset
*RTS shutter mode automatically switches over through TRIG IN
**RTS disabled under E-shutter OFF
(b)Multiple shutter
Multiple shutter via external trigger signal and external VD signal
*Operation like No.3, 6 above
(3)Restart / Reset
Restart / reset available via external VD signal
(Switching via rear panel DIP SW, Initial OFF)
Notes:
*The exposure-time (shutter-speed) is determined by external VD interval.
**Enabled when rear-panel DIP SW OFF.
***Provide consecutive HD.
