ENGINE OPERATION
36
7
1.
Joint
2.
Cap
4. Connect the primer bulb to the fuel
tank.
1.
Pull
2.
Insert
5. Squeeze primer bulb until it becomes
stiff to feed fuel to vapor separator.
Direc t arrow mark upward when
priming.
1.
Engine side
2.
Fuel tank side
Do not squeeze primer bulb with engine
running or when the outboard motor is
tilted up. Otherwise, fuel could overflow.
ENOM01805-0
ENOW00958-0
z
Do not remove or install the top cowl
after the engine has been started.
z
The exposed rotating engine parts or
moving parts cause serious injury.
ENOW00959-0
The top cowl must be installed while the
engine running except in an emergency. If
the top cowl is not installed correctly, water
splash can damage the engine.
ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump dam-
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
Run the engine only at idling.
And be sure to remove the propeller, when
star ting the engine in the test tank. (See
page 72)
Run the engine only at idling.
1.
Test tank
2.
Water
3.
Over 10 cm (4 in.)
1
2
ENOF02442-0
1
2
ENOF00861-A
1
2
ENOF00862-0
2. Starting the engine
WARNING
CAUTION
CAUTION
1
3
2
ENOF00863-0