23
it powers up in protect mode until the amplifier is warmed up and
the circuitry is filled with current.
4
After setting up your external source device with the frequency
generator program, follow the instructions in the program. Set up
your session for coiling by selecting a frequency (or frequency set),
intensity, and duration.
In setting up your session, be sure to use the
SQUARE WAVE for
your signal type. When you click the “start” or “play” button from
the program your session will begin. Sorry if we repeat this:
5
Check to see if the Signal Type LED is lit in one of the following:
GREEN
– Frequencies above 100Hz to 15kHz
GREEN
/
RED
– Frequencies from 5Hz to 100Hz
RED
– Frequencies that are out of range…below 5Hz or above
15kHz
PLEASE NOTE: The Signal Type LED may come on RED for less than
a second when you first start your Frequency Generator software.
6
Enjoy the benefits of the ELEMENT Elite.
Ending a Session
When your session for the day is finished, there are the obvious
things like turning the system power off and storing the coil so it
won’t get damaged.
There are also the less obvious. Be sure to drink plenty of water
and, most importantly, follow through with your detox protocols
as needed.
Additional Hints and Tips
■
This is essentially an audio device since it uses an audio source
frequency amplified to create the magnetic field at the coil. As
such, the amplifier will only reproduce frequencies within the
audio range (5Hz to 20,000Hz) which is further limited by the
working range of the coil (5Hz to 10,000Hz) in the same way that
a woofer in your speaker is limited to lower range frequencies
and will not play a high note.
■
If you find a frequency programmed in a routine you would like
