22
different, experimentation of relative intensity settings between
the two frequencies is encouraged to find what works best for you.
In all cases of intensity level settings, it is important to keep
in mind that you don’t have to run the machine at its maximum
output to achieve good results. It’s a little like having a high horse
power engine in your car...just because you have it, does not mean
you must go 100 mile per hour every time you drive (sorry we
repeated ourselves). On the other hand, it doesn’t benefit you to
drive at 5 miles per hour every where you go. It’s good to have the
power when you need it, but a little common sense and discretion
are well advised.
Begin a Session – follow these steps
It is important to be as comfortable as possible while having a
PEMF session. Discomfort puts additional mental and physical
stress on the body and thus will diminish (even if only slightly)
the effectiveness of the session. When setting up for a session,
choose a place where you can be comfortable. If the weight of the
coil is too much, use a towel to pad it. When possible, put one coil
on each side of your body, rather than one under and one on top
of your body.
Next, make sure you are using the correct frequency for the
issue you are dealing with. Some programs have pre-installed
frequencies for a whole array of maladies. Otherwise, some simple
research on the Internet can yield some great results.
1
Make sure you have:
■
…followed the initial set-up and hook-up instructions
■
…downloaded an appropriate frequency generator program to
your source device
2
Plug in one or both coils. If you’re using just one coil, it does not
matter which socket you plug it into.
3
Push and release the
POWER button located on the left side of the
Element Elite front panel.
You will hear the cooling fans come on. The left PROTECT
MODE light will come on for 2 – 3 seconds when the machine is
turned on. This is normal…it’s the amplifier’s built in protection…
