VS-32-L
5
The intended use of this strapping head is the bundling, combining and securing of
packing items in strapping machines.
Unintended use!
Strapping material must not be used for the hoisting of loads,
this strapping head
may only be used as intended and specified above.
The strapping head
VS-32-L
meets German and European safety requirements and
complies with the provisions in the following EU directives:
See Declaration of incorporation!
The
VS-32-L
is the suitable strapping head for medium and heavy packing items;
it does not matter whether those items are steel or stone, wood or glass.
The
VS-32-L
combines most modern driving and control technology with the state of
the art of patented TIG shield gas welding technology.
All functions are released by solenoid valves. Valves are equipped with actuating
magnets 24 V DC (direct current voltage).
The mains voltage of the
VS-32-L
head is 400 V 50/60 Hz. The connected load of the
welding unit is 6,6 kVA. Protect by fuse 16 A (slow-blow).
The welding seal can only be opened by means of an appropriate tool (strap scissors or
the like). Sealing strength is at approx. 90 % of the load at rupture of the strap
(depending on strap quality and dimension).
Adjustable strap tension of 4000-20000 N permits a good adaptation of the strapping to
the packing item.
The strapping head can be supplied in the following designs: for strap widths of 19, 25
and 32 mm.
Power and compressed air feed lines have
one
detachable quick-acting coupling each.
The mechanical joint of the strapping head and the machine is possible at various fitting
surfaces by means of four M16 bolts at the bottom of the drive housing and two of them
at the top. If required, two further M12 bolts on the fitting surface of the holding device
on the right. After the loosening of the four screws and the disconnection of the electric
power and compressed air ports the head can be replaced quickly and without
problems.
B 13 GB 33/06