15
4. Use the provided
fasteners to secure the
seam at the top and
bottom before setting the
next section into place.
I M P O R T A N T :
Use all of the bolt
holes in the seam
for joining the unit
sections together
and then tighten
accordingly.
Trim off the excess
caulk tape squeezed out
of the joint at each unit
joint to provide a clean
appearance.
5. After all of the sections are bolted
together, caulk the external section seam(s) to
provide a water tight seal.
IMPORTANT: Check all external sheet
metal seams for caulk shrinkage and re
-caulk if necessary.
Titan Air Inc. does
not warranty water damage equipment.
Unit seam sealing integrity should be
rechecked on a yearly basis.
NOTICE: Access door swings MUST be
kept free of installation piping and
wiring to allow for service and
maintenance.
6.Roof Cap Installation
Apply caulk to section roof tee before
placing on the splice cap.
Fasten splice cap to roof tee using the
provided self tapping screws from the top.
Caulk
