11
6. OPERATION INSTRUCTIONS
WARNING: LIFT OPERATION BY TRAINED AUTHORIZED PERSONNEL
OVER 18 YEARS ONLY. APPLY THE PARKING BRAKE AFTER POSITIONING THE
VEHICLE ON THE LIFT. DO NOT ALLOW ANYONE TO STAY IN LIFT AREA DURING
RAISING AND LOWERING CYCLES. CLOSELY WATCH THE VEHICLE AND THE
LIFT DURING RAISING AND LOWERING CYCLES. OBSERVE THE RATED LOAD
CAPACITY AND LOAD DISTRIBUTION. DO NOT ALLOW ANYONE TO CLIMB ON
LIFT OR STAY INSIDE VEHICLE. AFTER RAISING THE VEHICLE FRAME 6”, STOP
AND CHECK ADAPTERS FOR SECURE CONTACT. PERFORM BUMPER TEST(PG.2).
MAKE SURE THE VEHICLE DOORS ARE CLOSED DURING RAISING AND
LOWERING CYCLES.
WARNING: IN CASE OF DEFECTS OR MALFUNCTIONS SUCH AS JERKY
LIFT MOVEMENT OR DEFORMATION OF THE SUPERSTRUCTURE, SUPPORT OR
LOWER THE LIFT IMMEDIATELY. CONTACT QUALIFIED SERVICE PERSONNEL.
WARNING: PAY CLOSE ATTENTION WHEN SETTING THE LOCKS. THE
LOCKS MUST BE A LEVEL MATCH SET IN ORDER TO AVOID A VEHICLE TILT.
WARNING: ALWAYS LOCK THE LIFT BEFORE GOING UNDER THE
VEHICLE. NEVER ALLOW ANYONE TO GO UNDER THE LIFT WHEN RAISING OR
LOWERING.
6.1 DEFECTS / MALFUNCTIONS
6.2 CONTROLS
Once the up button is actuated, the lift moves up until the button is released or the limit stop
is reached.
6.2.1 UP CONTROL
6.2.2 SAFETY LOCK CONTROL
The safety latch mechanism will “Trip Over” as the lift raises and drop into each safety latch
stop. To lock the lift you must press the lowering handle on the power unit (Fig. 1) to relieve
the hydraulic pressure and let the safety locks engage into a level locked position.
