Timken ROLLON SC 100, Use And Maintenance

Page: 9 / 18

UM-7
Smart System
Fig. 22
Fig. 23
Fig. 24 Fig. 25
Assembly of clamp/brake unit (only for SC130 and SC160)
1) Remove the screws and the plates on both sides of the car-
riage (see Fig. 22).
2) Assembly the clamp/brake on the plate taking care about the
right orientation as shown in the picture. Before tightening
completely the screws push the clamp/brake against the
reference sides on the plate. Assembly the air plug on the
clamp/brake as shown in the picture (see Fig. 23).
3) Connect the air tube to the plug.
Give pressure in order to unlock the clamp/brake.
4) While assembling the plate with the clamp/brake mounted on
it take care to put the reference of the plate in contact with
the carriage (see Fig. 24).
5) Re-assembly the plate to the actuator without firmly tighte-
ning the screws.
6) Cut air pressure, the clamp/brake is now clamping on the rail.
7) Tight all the screws of the plate.
8) Give air pressure so that the brake is released and check that
the actuator is free to move.