TIGIEFFE AIRO R Series, Use And Maintenance Manual

Page: 57 / 114

Use and Maintenance Manual - R13 R17 Series Page 57
6. HANDLING AND CARRYING
6.1. Handling
To handle the machine in normal operating conditions follow the instructions given in chapter "GENERAL USE INSTRUCTIONS"
under paragraph "Drive”.
When platform is completely lowered (regardless of JIB position, even raised) you con operate the machine (carry out drive) using
the drive controls.
With one or more outriggers resting on the ground, drive is inhibited.
WARNING!
Before carrying out any displacement operation, verify that no people are in proximity of the machine and in
any case proceed with the utmost caution.
Before handling the machine check that the connection plugs are disconnected from the power supply
source. On machines with AC electric pump (optional) always check the position of the power cord during the
movements.
Check that there are no holes or steps on the floor and bear in mind machine overall dimensions.
Do not use the machine to tow other vehicles.
If the machine is equipped with the option "tracks enlargeable", check that the tracks are completely slipped
off or fully retracted, according to the type of work to do. It is recommended to use the narrow track width
only when required to cross reduced spaces.
6.2. Carrying
In order to carry the machine to the various working sites, follow the instructions given below. Considering the large dimensions of
some models, before carrying, it is recommended to inquire about the overall dimension limits for road transport in force in your
country.
Before carrying the machine, turn it off and remove the keys from the control panels. No people are allowed in
proximity to or on the machine to avoid any risks deriving from sudden movements.
For safety reasons never lift or tow the machine by means of its booms or platform.
Loading operations are to be carried out on a flat surface with a suitable capacity, after setting the platform to
rest position.
To carry the machine the operator shall load it onto a vehicle either:

By means of loading ramps and translation controls
to load it directly onto the vehicle (if ramp slope is within
the gradeability described in paragraph “TECHNICAL
FEATURES” and capacity is adequate to machine
weight) according to the instructions given in paragraph
“GENERAL USE INSTRUCTION” under paragraph
“Translation” for correct operation of drive controls.
Block the vehicle using the parking brake. Make sure
there are no people nearby. Position the pair of ramps of
suitable dimensions and set them in line with the machine
tracks (check capacity). Make sure the ramps slope is not
exceeding the machine gradeability and ramps are
perfectly free from grease, mud, snow or ice.
Fig. 21