Tiger JD5085-5115M T4F, Mounting And Operating Instructions

Page: 99 / 194

OPERATION
TRIPLE FLAIL Operation Section 3-39
© 2012 Alamo Group Inc.
OPERA
T
ION
15. TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE REMEDY
Excessive Vibrations Check gearbox bolts. Tighten if loose.
Check for missing knives on Replace missing knives.
cutter shaft.
Check to see if knives are
Free knives so they swing.
free swinging.
Blade broken or bent.
Replace blades.
Cuttershaft bent. Replace cuttershaft.
Drivelines not phased correctly. Replace driveline.
Implements & Tractor yokes
must be in line.
Gearbox Overheating Low on lubricant. Fill to level plug.
Improper type lubricant. Replace with proper lubricant.
Excessive trash build-up Remove trash.
around gearbox.
Bearing or gears set up
Consult your Dealer.
improperly.
Gearbox Noisy Rough Gears. Run-in or change gears.
Worn Bearing. Replace bearing.
Noise Damaged Belt Shield Straighten or replace shields.
(Rubbing on pulleys or belt).
Worn Bearing or Gear.
Gearbox Leaking Damage oil seal. Replace seal.
Bent shaft. Replace oil seal and shaft.
Shaft rough in oil seal area. Replace or repair shaft.
Oil seal installed wrong. Replace seal.
Oil seal not sealing in the Replace seal or use a sealant on
housing. OD of Seal.
Oil level too high. Drain oil to proper level.
Sand hole is casting. Replace castings or gearbox.
Gasket damaged. Replace gasket.
Bolts loose. Tighten bolts.