Tiger JD5085-5115M T4F, Mounting And Operating Instructions

Page: 117 / 194

MAINTENANCE
TRIPLE FLAIL Maintenance Section 4-15
©2016 Alamo Group Inc.
MAINTENANCE
ADJUSTING THE CUTTING HEIGHT
Loosen the four ground roller bracket locknuts.
Loosen the adjustment rod locknut and turn the
adjustment rod to adjust the cutting height. The
cutting height is indicated by the end of the
adjustment rod on the cutting height decal. When
cutting height has been achieved, tighten the
ground roller bracket locknuts and the adjustment
rod locknut securely. Be sure both sides of the flail
are adjusted the same.
ADJUSTING STANDARD DUTY CUT HEIGHT
To adjust the cutting height of the standard duty flail
head the two nuts on the roller shaft brackets must
be taken off and moved to the desired location/
height. Be sure that both sides of the shaft are
adjusted to corresponding holes so the shaft
remains level.
GREASING P.T.O. SHAFTS
After bringing the tractor to a complete stop, shut off
the engine and remove he PTO shaft from the
tractor. Slide the shaft apart to expose the grease
zerk. Grease the shaft with 5 pumps of grease and
the U-joints until grease protrudes from caps per
the scheduled interval in the maintenance section.