Tiger JD5085-5115M T4F, Mounting And Operating Instructions

Page: 124 / 194

MAINTENANCE
TRIPLE FLAIL Maintenance Section 4-22
©2016 Alamo Group Inc.
MAINTENANCE
REVERSING MOWER ROTATION REAR MECHANICAL DRIVEN FLAIL
MOWERS
Remove the rear shaft guard and disconnect the
chain coupling to the shaft. Disconnect the P.T.O.
drive shaft from the right angle gear box. Remove
the gear box from the flail frame and lay down flat
so that gear oil does not leak not.
Switch the top breather vent plug with the drain plug
on the bottom. Remove the input shaft guard. The
input shaft must be pressed through or turned
around so the rear extension is equal to what the
original front dimension was. Turn the gear box
180° and install on the flail frame so the frame so
the chain coupling sprockets are side be side and
the breather vent plug is on the top of the case.
The sprocket must be aligned and spaced approximately 3/8” apart. When changing from standard cut to
smooth cut rotation, a spacer plate may have to be installed between the gear box and the frame. When
changing from smooth cut to standard cut rotation the spacer plate is to be omitted. Install the chain for the
chain coupling. If there is any binding, or not free movement in the chain, the bearing next to the coupler may
be shimmed as required to eliminate the chain binding.
Change all the knives on the cutter shaft as required. The cutter shaft rotates in the same direction as the
tractor tires when going forward for standard knives. The cutter shaft rotates opposite the tractor tires for
smooth cut knives.
Remove the belt shield. Then remove the adjusting nuts, washer and spring from the idler tensioning rod.
Remove the clevis rod and small bushing from the idler arm. Remove the idler arm with the pulley attached.
Remove the idler pulley from the idler arm and install the pulley on the other end of the idler arm. Reinstall the
idler arm in the pivot bracket. For standard cut rotation the pulley is toward the front, for reverse rotation with
smooth knives, the idler pulley is toward the rear. Install the small bushing in the idler arm and connect the idler
tensioning rod.
Tightening the adjusting nuts for the idler arm tensioner as shown previously in the maintenance section. Install
the belt shield, the shaft guard and P.T.O. shaft guards.
When operating the mower in reverse rotation with
smooth cut knives, remove the baffle and install the
front shield. When operating the mower in standard
rotation with standard cut knives, remove the front
shield and install the baffle.