TIGA e-Park 220, Instruction Manual

Page: 34 / 48

EN - 12
H9.
Batteryover-temperature
(see chap. 15).
H10. Over-temperature
of controllers and/or
engine
(see chap. 15).
6.11.2
Batterychargescreen
The battery charge screen (Fig. 8) activates
when battery charging is started (par. 8.4.2)
and serves to indicate the percentage
reached by the battery charge.
7. USING THE MACHINE
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
7.1 PREPARATION
Before starting to mow, it is necessary to carry
out several checks and operations to ensure you
can work eiciently and in maximum safety.
Place the machine in a stable
horizontal position on the ground.
7.1.1
Seatadjustment
The seat can be reclined and be
moved forwards and backwards.
The seat can be locked in the reclined
position using the stop (Fig. 9.B).
To adjust the seat to the required position:
•
Loosen the screws (Fig. 9.A).
•
Move the seat to the required position.
•
Tighten the screws (Fig. 9.A).
The seat will be damaged if the screws
are tightened to a torque exceeding 24 Nm.
NOTE The seat is equipped with a safety
switch connected to the safety system of
the machine. This means that when the
driver is not sitting in the driver's seat, or
stands up from the seat, the controls cannot
be activated and no actions which could
compromise driver safety can be carried out.
7.1.2
Tyrepressure
Having the right tyre pressure is the main
condition for ensuring that the cutting means
assembly is horizontal and mows evenly.
1.
Unscrew the valve caps
2.
Connect a compressed air line with
a gauge to the valves (ig. 10)
3.
Adjust the pressure according to the values
indicated in the "Technical Data" chart.
7.1.3
Checkingthebattery
Charge the battery fully before
using the machine for the irst time
after purchase (chap. 8.4.2).
Always check the battery state of charge
before using the machine (Fig. 7.H).
7.2 SAFETY CHECKS
Run the following safety checks and
check that the results correspond to
those outlined on the tables.
Always carry out the safety
checks before use.
7.2.1
Generalsafetycheck
Object
Result
Electrical cables
and battery cable.
All insulation intact.
Blade motor. Coolant air inlet grille not
clogged. Integral, no damage
.
Display. Clean, integral, no damage
.
Controls
.
Integral, no damage
.