ThyssenKrupp Drive DAB530, Operating Manual

Page: 25 / 86

O
PERATING MANUAL
DAB530
M
OUNTING THE MACHINE
ThyssenKrupp Aufzugswerke GmbH
5. Mounting the machine
5.1 Machine setup
The DAB530 machine is delivered fully mounted and aligned on the machine
base frame, including rope pulley (double wrap).
The base frame is set up depending on the installation on the machine room
floor or directly in a cement floor.
In order to comply with regulations for noise abatement and sound
transmission, insulation elements are to be inserted between the frame
supports and the ground. These differ depending on the type of mounting:
a)
Rubber block 100 x 100 x 50 high without base
For mounting the machine on the machine room floor without a cement floor
or directly surface mounted on the cement floor.
b)
Rubber block same as a), but with an additional base 140 x 140 x 80 mm
high, for mounting on a cement floor, support cast in cement floor. (coating
thickness

60 mm) The support is also to be cemented in place.
The number of rubber elements is based on the total load.
The required individual load should be between 7000 and 12 000 N / per
element.
On arrangement of the supports, it is to be taken into account that the overall
centre of gravity lies within the rubber elements.
You will find the versions and dimensions of the machine base frames in
Chapter 3
5.2 Aligning the machine base frame
The machine is to be set up according to the plan of installation (drawing).
The rope departure from the traction sheave and rope pulley (double wrap) is
to be aligned plumb according to the drawing on the elevator car rope pulley
or the counterweight pulley. With load applied to the ropes, the machine
should be aligned horizontally on its installation surface. Irregularities are to
be balanced out by inserting shims under the support.
Rope arrangement:
The arrangement of the carrier cables in the suspension
plate, on the traction sheave as well as the cable rollers should be as
symmetrical as possible
.
Alignment of the machine on the base frame:
the machine is aligned on
the base frame in such a way that the axle alignment of traction sheave and
rope pulley (double wrap) are exactly parallel. The lateral location of the rope
grooves must be offset by half of the groove gap dimension. The parallel
dimension of the gap (ASL) of the outgoing ropes is to be complied with.
(See Figs. 3.1 - 3.5)
25 Version 03/2017