THOMSON DD10, Installation Manual

Page: 94 / 179

6. Initial Installation Diamond digital
85
The header line TIMING displays the source selected on bus Video store with the
defined source name with the current status (e.g. IN03: no signal).
The bar diagram under the header line displays the timing of the sources in the area
of the auto phaser. Both arrows mark the area in which the phase relation of the
sources can correctly be set for all mixer buses. In the correct timing range, the
bar is light. A dark bar indicates that the source does not lie in the valid area. This
can also happen when the display is between the arrows!
Attention:
At DD5 and DD10, the mode of representation of the menu monitor can be
changed (e.g. to inverse representation) by means of switch T4 on the con-
trol panel controller. Thus the bar colors and also all other softkeys can be
displayed in the menu in an inverted way.
The right arrow marks the earliest mixer input (latest timing of the sources). The
left arrow marks the earliest timing of the sources.
When adjusting the genlock phase, switching procedures in the genlock effect
again a running in of the H phase. This is indicated in the bar diagram as bounces.
In this case, the run-in procedure has to be waited for.