pg. XXII
5.4 CHR
5.4 CHR
5.4 CHR
5.4 CHR
5.4 CHRONO
ONO
ONO
ONO
ONOTHERMOST
THERMOST
THERMOST
THERMOST
THERMOSTA
A
A
A
AT
T
T
T
T::::: ON/OFF PR
ON/OFF PR
ON/OFF PR
ON/OFF PR
ON/OFF PROGRAMMING
OGRAMMING
OGRAMMING
OGRAMMING
OGRAMMING
4
1
5
3
7
2
6
DAYS MON
00 : 00
ON 1
Press button (1) repeatedly to display the desired day in which to enter or change the programming.
Press the button (2) to confirm.The following indications appear next on the display:
DAYS MON
ON 1
00 : 00
the figures relating to the hours programming for the first startup (ON 1) begin to blink.
Press button (3) and/or (4) to change the hours. P
ress the button (2) to confirm.
The following indications appear next on the display:
DAYS MON
00 : 00
ON 1
the figures relating to the minutes programming for the first startup begin to blink (ON 1).
Press button (3) and/or (4) to change the minutes. P
ress the button (2) to confirm the value.
The following indications appear next on the display:
DAYS MON
00 : 00
OFF 1
now press button (2) once again and the figures relating to the hours programming for the first
shut off (OFF 1) begin to blink. Similarly, as described above, proceed to enter the hours and
minutes for the first shut off (OFF 1). Next proceed to program the other on - off cycles for
Monday and for the remaining days of the week .
In the event of a programmed cycle on always ensure that the brazier is clean:
failure to keep the brazier clean can reduce the life of the spark plug.
To exit programming simply press button (6): the operating status of the heater/boiler will now appear on the display. Press button (5), while
the heater/boiler is running, to enable or disable the programming function.
(when you press button (5) the words ON CHRONO or OFF CHRONO will appear on the display accompanied by the fixed presence or the
absence of the symbol).
The heater / boiler must be energised and the switch at the back turned to position "1".
It is possible to execute the weekly programming by setting up to 3 on-off cycles for each day from Monday to Sunday. To access the
programming mode press the button (6) repeatedly until the word CRONO appears: wait a few seconds for the following indications to
appear on the Display (7):
17 : 15
Simbolo presente : programmazione abilitata
WORK
60
65
WORK
17 : 15
60
65
Simbolo presente : programmazione disabilitata
Symbol displayed: programming enabled
No symbol: programming disabled
Summary of Contents for ECOTHERM H20 14
Page 30: ...pg XXX K E Y F i g u r e 4 5 6 7 K E Y F i g u r e 4 5 6 7 ...
Page 31: ...pg XXXI ...
Page 32: ...pg XXXII ...