pg. XXI
5.2
5.2
5.2
5.2
5.2
DESCRIPTION OF
DESCRIPTION OF
DESCRIPTION OF
DESCRIPTION OF
DESCRIPTION OF THE REAR P
THE REAR P
THE REAR P
THE REAR P
THE REAR PANEL
ANEL
ANEL
ANEL
ANEL
11
12
13
14
15
10
9
8
17
16
(8)
Power outlet for additional room temperature connection.(see para.
6.1)
(additional room temperature thermostat not supplied ))
(9)
Power outlet for additional chronothermostat connection.(see para.
6.2)
(additional chronothermostat not supplied )
(10)
Loading motor test LED. The light must come on when the pellet screw
feeder starts.
(11)
Reset thermostat tripped indicator light. This LED comes on when the
reset thermostat is activated.
(12)
Main switch 0-1
(13)
Electrical power outlet for heater / boiler 220-240V 50Hz.
(14)
General fuse 3,15 A.
(15)
Clamp for connecting Sensor 1 (see hydraulic drawing 4.8)
(16)
Clamp for connecting Sensor 2 (see hydraulic drawing 4.8 )
(17)
Overtemperature thermostat button cap.
In the event of overtemperature this safety thermostat stops the loading of pellets. When it is activated LED 11 comes on. To restart
the heater you have to wait until the water inside it cools down, then verify the cause for the overheating, remove the cause,
unscrew the protective cap and press the button.
5.3 D
5.3 D
5.3 D
5.3 D
5.3 DA
A
A
A
AY
Y
Y
Y
Y AND
AND
AND
AND
AND TIME SETTING
TIME SETTING
TIME SETTING
TIME SETTING
TIME SETTING
The heater / boiler must be energised and the switch at the back turned to position "1".
To set the clock and the day of the week carry out the procedures described below. Press button (6) repeatedly until the word DATE
appears on the Display (7); wait a few seconds for the following indications to appear on the Display (7):
4
1
5
3
7
2
6
DAYS MON
00:
MON
00:00
MON
the figures relating to the minutes on the clock begin to blink. Press button (3) and/or (4) to
change the minutes. Press the button (2) to confirm. The day and time setting is now
completed : the operating status of the heater/boiler will now appear on the display.
The dot/s begins/begin to blink. Press button (3) and/or (4) to change the day of the week (
... TUE o o ... WED o o o ... THU o o o o ... FRI o o o o o ... SAT o o o o o o .. SUN o o
o o o o o ..). Press the button (2) to confirm. The following indications appear next on the
display:
the figures relating to the hours on the clock begin to blink. Press button (3) and/or (4) to
change the hours. P
ress the button (2) to confirm. The following indications appear next on the display:
Summary of Contents for ECOTHERM H20 14
Page 30: ...pg XXX K E Y F i g u r e 4 5 6 7 K E Y F i g u r e 4 5 6 7 ...
Page 31: ...pg XXXI ...
Page 32: ...pg XXXII ...