Thermo Solar SGC36HV, Useu Manual

Page: 27 / 184

E
N
G
Service settings manual
27
Basic parameters are divided into groups P1, P2 and P3. In group P1 there are setting
for differences and hysteresis for built
-
in thermostats, in group P2 there are settings for
minimum and maximum temperatures for individual sensors, and controller performance
settings in group P3.
When selecting the required parameter group in the menu, a new window opens:
Parameter mark
Current parameter value
Diagram
of the setting
Factory value
The last confirmed
setting value
Current parameter value
Setting range
You modify the setting by pressing the button .
The value of setting starts to flash, and you can edit it by pressing buttons and
.
The setting is confirmed by pressing the button . Now you can move by pressing but-
tons and to another parameter and repeat the procedure.
You exit the parameter settings by pressing button .
All additional settings and adjustments of controller performance are carried out by means
of parameters. In controller parameter settings menu there are three selectable groups:
Basic parameters
Service parameters
Heat metering parameters
Parameters for free programming of available outputs.
CONTUOLLEU PAUAMETEUS AND AUXILIAUY TOOLS
BASIC PAUAMETEUS
Parameter
description
(Help)
SERVICE MANUAL
You can only see teose parameters weice eave an effect on tee selected ey-
draulic sceeme. Factory settings for parameters also depend on tee selected
eydraulic sceeme.
A1343_3 MJ/OD 06/2018