Thermo Scientific Surveyor UV Plus, Hardware Manual

Page: 30 / 76

2
Installation
Making the Back Panel Connections
14 Surveyor UV/Vis Plus Detector Hardware Manual Thermo Scientific
Making the Back Panel Connections
Use the cables provided in the UV/Vis detector accessory kit to make the back panel
connections.
For a stand-alone Surveyor LC system, you must connect the UV/Vis detector to the data
system computer as described in
“Connecting the UV/Vis Detector to the Data System
Computer” on page 15 . You must also connect the system interconnect cable that transmits
the start signal from the autosampler to the detector during an injection cycle as described in
“Making the Contact Closure Connections” on page 16 .
If you are using an autosampler that is not controlled from your Thermo Scientific data
system, use the remote communications pins on the detector’s back panel to trigger the
detector as described in
“Making Remote Communications Connections” on page 21 .
To make the back panel connections, follow these procedures:
• Connecting the UV/Vis Detector to the Data System Computer
• Setting the Unit ID
• Making the Contact Closure Connections
• Connecting the Analog Outputs
• Setting the Analog Output Voltage
• Making Remote Communications Connections