Thermo Scientific Orion 310, Instruction Manual

Page: 27 / 81

23
PerpHecT ® Orion 310, 320, 330 Instruction Manual
Chapter IX
Using the Orion 320
A. Power-Up
Plug meter into an approved wall outlet via the power line adaptor.
The entire display (all annunciators) will be displayed for 2 seconds.
Once all power-up procedures have been completed, the meter
automatically advances to measure mode.
NOTE: If this is the first time that the meter has
been powered up, it is recommended that the
Self-Test Procedure be performed before using
the meter for measurements.
B. Meter Self-Test Procedure
It is recommended that this procedure be performed when the meter is
operated for the first time or any time that operational problems arise.
For a description of the diagnostic tests, see Chapter XVIII Self-Test
Definitions pg 53.
This procedure verifies the proper operation of the PerpHecT meters.
Self-test
1. Attach shorting cap to electrode BNC input.
2. Plug line adapter (Orion 020125) securely into meter Line Adapter
Input then into an appropriate wall outlet, while pressing the YES
key (hold down for 3 seconds) to start the self-test. The meter will
automatically perform seven diagnostic tests.
3. When “0” appears in the display field, press each key once.
A numeric digit will be displayed upon each keypress.
4. After the self-test is completed, the meter will automatically go
to MEASURE mode.
5. If any problems are found during the self-test, see Operator
Assistance Codes, page 55.
Using the Orion 320