Thermo Scientific OGS 100, Operating Instructions Manual

Page: 50 / 110

Start-up
Table-top units
5-4 Heratherm Thermo Scientific
2. Clamp the retaining spring [3] behind the upper embossing [1].
3. To remove the support rails, pull the retaining spring tab down out of the embossing and
remove the support rail assembly.
Installing an Uninstalling the Rear Air baffle (OMS Series only)
Heratherm OMS Series ovens are shipped from the factory with an air baffle readily
pre-installed at the back wall of the work space (while OGS Series ovens do not have this
feature). Before the air baffle can be removed from the back wall, the support rails need to be
uninstalled as explained further above.
Figure 5-5 Installing the Rear Air Baffle
1. Losen the two screws [1] that hold the air baffle to the back wall of the work space.
2. Grab the two retaining springs [2] at their tabs and pull them downwards out of the
embossings, then pull off the rear air baffle.
3. For the rear air baffle to install correctly, the two retaining springs [2] must be facing
upwards. Place the air baffle on the lower embossings and tilt it upwards against the back
wall of the work space.
4. Clamp the two retaining springs [2] into the upper embossings.
5. Secure the air baffle to the work space back wall by fastening the two screws at [1].
Risk of damage to sensor!
To prevent accidental damage, be sure to avoid collision with the sensor
when installing or uninstalling panels in the oven‘s workspace.