Thermo Scientific OGS 100, Operating Instructions Manual

Page: 30 / 110

Installation
Floor stand unit spacers (not with 3P units)
3-14 Heratherm Thermo Scientific
Floor stand unit spacers (not with 3P units)
The spacer on the electrical module must be pulled out and fixed in place before installing
the floor stand unit at its installation location.
1 Loosen the 2 screws
2 Pull out the spacer and slide the screws into the recesses
3 Tighten the two screws
Risk of tipping and dropping of
stacked devices
You should be aware at all times that stacked devices do not form a
stable unit, even when the stacking pads and frames are used
correctly. The top device may tip over and drop down when being
transported in a stack. To avoid injury to persons and damage to
equipment, do not attempt to move stacked devices as a unit!
Separate and move each device one by one, then restack them.
Thermo Scientific accepts no responsibility or liability whatsoever
with regard to stacked third party devices; this is at the user’s own
risk.