Structural Maintenance
142
Jackshaft Assembly
The RD-II MAX 30 does not have electric
standby capability, therefore, the electric motor is
replaced by a jackshaft. The jackshaft assembly
oil level plug should be removed, and the oil level
checked every 1000 operating hours. Check the
jackshaft during the pre-trip inspection for oil
leakage. If there is any sign of leakage, remove
the jackshaft assembly.
Model 30 truck units are equipped with jackshafts
that have improved venting. This improvement
was made by using a new air vent (P/N 55-6417),
adding an oil sling retainer (P/N 77-2434), and
using fanshaft oil (P/N 203-278). The new air
vent, oil sling retainer, and fanshaft oil reduce the
build-up of pressure inside the jackshaft.
Disassembly
1. Remove jackshaft assembly from the unit and
remove the pulleys.
2. Remove the level and fill plugs and drain oil
reservoir.
3. Remove bearing retainer cap from fill plug
end of the jackshaft assembly.
NOTE: There are shims between the bearing
retainer cap and the housing. These should be
saved for possible reuse during reassembly.
4. Remove the shaft and bearings.
NOTE: The oil sling retainer is pulled out by the
bearing assembly on shaft.
5. Remove the retainer cap from level plug end
of assembly.
6. Use a punch and hammer to remove the seals
and bearing cups from bearing retainer caps.
7. Use a bearing splitter or similar tool to remove
the bearing cones from the shaft.
8. Clean all parts in clean solvent and then
examine the bearing cups and cones for
damage.
1.
Move Angle Down
2.
Move Angle Up
Figure 64: Defrost Damper Adjustment
1
2
AEA924
Incorrect
Incorrect
Correct
1.
Fill Plug and Vent
2.
Oil Level Plug
Figure 65: Jackshaft Assembly
Summary of Contents for 914970
