RC3 BP™
Operation
4-5
NOTE
To prevent accidental erasure of established programs,
if the entered program number has been previously
assigned, the following message will appear:
IN USE - OVERWRITE?
(1=YES, O or ENTER=NO)
To review stored programs before overwriting, refer to
your Program Log Pad or press RECALL. If you press
RECALL, you will have to go back and reestablish the
run parameters before you can store them to memory.
B. Performing a Programmed Run
Read the Safety Information Page at the front of this manual.
1. Press RECALL – the HOME screen will change to display a
program number flashing in the PROG # field.
2. Input the desired program number, then press ENTER – the SET
display and options indicators change to reflect the run param-
eters that were saved to that program number.
3. Prepare the rotor according to the rotor manual instructions.
4. Open the chamber door and install the rotor, making sure that
the rotor is fully seated and locked to the drive spindle. Install
the rotor cover, if any, then close the chamber door.
NOTE
Rotor names are not saved or recalled – be sure that the
installed rotor is correct for the recalled program; make
sure that the SET rotor identifies the installed rotor.
5. If using WatchLog Network™ run logging software, make sure
it is running, then press START (indicator will light).
The rotor will accelerate according to the recalled parameters, and
continue until run termination. At termination, the STOP indicator
will light and the rotor will decelerate to a stop. After it stops,
START and STOP indicators will turn OFF, and "End" will appear in
the SPEED display and remain there until the door is opened.
Using Advanced Features (Options)
The advanced features of the
RC3
BP™ allow for: performing qual-
ity control runs, changing speed or time control ranges, changing
acceleration/deceleration or overtemperature alert settings, link-
ing-together programmed run parameters, and saving run
parameters to program memory for simple recall. Detailed descrip-
tion of each of the advanced features can be found in Chapter 3.
Summary of Contents for SORVALL RC3BP
