Thermcraft XST-2-0-12-1V1-E28, Instruction Manual

Page: 212 / 260

Programmer Operation Installation and Operation Handbook
5.3 Running A Program From The Run List
From the Home display, press until you reach the ‘
run
’ list header.
Press
This display will only appear on controllers that can hold more than one
program (Models 2416/P4 & 2416/V4). Use or to select the required
program number, from 1 to 4.
Press
Status selection
Use or to select:
• run
Run program.
• hoLd
Hold program.
•
OFF
Program reset.
After two seconds, the lower readout blinks and the chosen state is now active.
To return to the Home display press and together.
To access the other parameters in the ‘
run
’ list, continue to press . These
parameters are shown in the ‘Program run list’ in Chapter 2, Parameter Tables.
They show the current status of the active program.
Temporary changes can be made to the parameters in this ‘
run
’ list, (for example a setpoint, ramp rate, or an
unelapsed time), by first placing the programmer into ‘
hoLd
’. Such changes will remain active only for the
duration of the segment; the segment parameters will revert to their original (stored) values whenever the segment
is re-executed.
The Run List
Program number
Other parameters
Temporary changes

run
LiSt
StAt
OFF

PrG
1
5-4 HA025041 issue 12 Aug 14