Theratherm 09i, User And Service Manual

Page: 19 / 47

17 A Division of:
Note: Under Automatic mode, it is useless to set parameter P1 .
Operation logic of Auto Mode:
Set water temperature
(Tset)
Current water in
temperature
(Tset +2
℃
)
Current working
mode
After 3 minutes or
above, it will switch
to
Tset (eg: 28
℃
)
Tset +2
℃
(eg:30
℃
)
Heating mode
Cooling mode
Tset (eg: 28
℃
) Tset-2
℃
(eg: 26
℃
) Cooling mode Heating mode
6.2.3 button
Lock/unlock the display:
Hold for 5 seconds to lock/unlock the display.
Water temperature setting :
Press to set the water temperature directly.
Parameter checking :
Press first, then press to check the “ User parameter from d0 to d11”.
Code Condition Scope Remark
d0 IPM mould temperature 0-120
℃
Real testing value
d1 Inlet water temp. -9
℃～
99
℃
Real testing value
d2 Outlet water temp. -9
℃～
99
℃
Real testing value
d3 Ambient temp. -30
℃～
70
℃
Real testing value
d4 Frequency limitation code 0,1,2,4,8,16 Real testing value
d5 Piping temp.
-30
℃～
70
℃
Real testing value
d6 Gas exhaust temperature 0
℃～
C5
℃
(125
℃
) Real testing value
d7 Step of EEV 0
～
99 N*5
d8 Compressor running frequency 0
～
99Hz Real testing value
d9 Compressor current 0
～
30A Real testing value
and
and
or