15
A Division of:
(3)It is recommended that your pool filtration pump and your heat pump are wired independently.
Disconnect:
A disconnect means (circuit breaker, fused or un-fused switch) should be located within sight of and
readily accessible from the unit. This is common practice on commercial and residential heat pumps. It prevents
remotely-energizing unattended equipment and permits turning off power at the unit, while the unit is being serviced.
5.2 Installation of the display deportee
Photo(1)
Photo(2)
Photo(3)
Photo(4)
Photo(5)
-
The side with plug connects with the control panel (photo 1)
-
The other side of the signal wire. (photo 2)
-
Open the wiring panel and put the side without plug through the electrical box. (photo 3, 4)
-
Insert the wiring into the designated position (
code:COM 1 or COM-L)
on the PC board. (photo 5)
Summary of Contents for 09i
